Caisson lock
This article needs additional citations for verification. (March 2022) |
The caisson lock is a type of canal lock in which a narrowboat is floated into a sealed watertight box and raised or lowered between two different canal water levels. It was invented in the late 18th century as a solution to the problem posed by the excessive demand for water when conventional locks were used to raise and lower canal boats through large height differences. Such locks, each of which would only raise and lower boats through small height differences of a few feet, would not suffice when large height differences had to be tackled nor when water was in short supply. The caisson (or caisoon) was thought to be one solution, although it transpired that the technology of the day was not capable of achieving this type of construction economically.
It was designed primarily as a water-saving measure, and also was an attempt to minimise construction costs compared with other engineering solutions of the time. In use it was capable of replacing up to seven conventional locks.[1] Other design benefits were speed of boat descent/ascent, and only a little loss of water when operating compared with a conventional boat lock.
History
The caisson lock was first demonstrated at Oakengates on a now lost section of the Shropshire Canal in 1792, where its inventor, Robert Weldon (b:?1754, d:1810) built a half-scale model. He claimed that his design would solve the problem of water supply in dry seasons or at greater elevations, be cheaper than building aqueducts or tunnels, and be quicker to operate than the number of surface locks his design could replace.[2] He patented his invention as the 'Hydrostatick Caisson Lock'. The full-sized box, or "trunk",[2] would probably have displaced about 270 tonnes and weighed about 170 tonnes, including the water in it, so about 100 tonnes of ballast would have been needed to give neutral buoyancy. The box would have needed to be strong enough to withstand the pressure of 50 ft (15 m) of water i.e. about 22 psi (150 kPa) gauge pressure at the bottom of the chamber.[3]
The first lock was completed in 1797 under Weldon's supervision. The device was demonstrated to the Prince Regent (later George IV), but was found to suffer from various engineering problems, possibly caused by the soft fuller's earth rock stratum in the area.[4][5][6]
Method of operation
The system depended on the submerged, sealed box (the "caisson", from the French for "large chest"[7]) being heavily ballasted to achieve neutral buoyancy, so it was never possible in ordinary operation to lift it to water level to allow a descending boat to float in. Instead, a masonry chamber ("cistern") was built with walls higher than the water level in the top pound and itself filled completely with water, so that even at its upper position the box remained below the surface.[8]
Abandonment
The May 1799 test, above, occurred when a party of investors was aboard the vessel and they nearly suffocated before they could be freed. Work on the second lock was suspended (the third lock had not been started) and early in the following year an inclined plane, to carry boats’ cargoes in wheeled tubs, was built instead. Eventually a flight of nineteen locks on a longer alignment up the slope was constructed, with a Boulton & Watt Steam Pumping Station, capable of lifting 5,000 tons of water in 12 hours, used to recirculate the water.[9]
Other installations
In April 1815 the Regents Canal Company built a double caisson lock (or "hydro-pneumatic lock"[10]) at the site of the present-day Hampstead Road Lock, north London. The designer was military engineer William Congreve. Here the motivation was, principally, water supply problems but also to effect a quicker passage of vessels, as those going in opposite directions could pass in the lock. The caissons—always submerged, as at Combe Hay—were without bottoms and were arranged so that their sides dropped into deep underwater channels formed by "minor walls" inside the main walls. The vertical movement of the two caissons was effected by a balance pipe ("the channel of communication") passing under the lock floor between the two caisson chambers (but with a slight upturn to reach above the water levels), so that causing an increase of water level in one caisson ("the water of compression") displaced air through the pipe, thus forcing a corresponding decrease in the water level in the other. This increased the buoyancy of the latter caisson, which accordingly rose as the first sank. A connecting underwater chain passing through rollers, while not in itself doing any work, controlled the relative positions. Boats were admitted through double gates; the inside ones on the caisson "adjusted to fit close [sic] to those of the outer".[11] Congreve's patent then envisaged that having achieved "absolute equipoise" (neutral buoyancy) a rack-and-pinion, removable weights or a small winch could overcome inertia and move the caissons. In a practical demonstration at Hampstead Road Congreve later elected to deploy an air compressor releasing into one caisson, estimating that one man could achieve raising and lowering in three minutes—the company's enabling act did not permit the installation of stationary steam engines.[12] However it was found the fastest overall time was six minutes and that the effort required rendered the operator "incapable of further exertion". Furthermore, as the operation of the device depended upon air pressure inside the caissons (whether the means of moving them was by varying this air pressure or otherwise) when contractor Henry Maudslay delivered them and they were found to leak air, the scheme failed. In 1818, after many unsuccessful repair attempts, the company substituted conventional locks.[13][14]
A patent granted to Jonathan Brownill, a cutler from Sheffield, on 1 May 1828, while in principle operating as an open-air balance lock, was described as using three caissons. The main caisson was connected by ropes passing over grooved pulleys to two smaller, counterbalancing caissons. Brownill's innovation was to place wedges ("inclined planes") opposite the upper and lower fixed openings so that as the main caisson moved into place, powered by water being added or released from the counterbalancing caissons, rollers acting against the wedges forced it against a padded frame surrounding the opening. The "conductor" was to have control of a lever to release the rollers when the vertical gates were slid shut for the next ascent or descent.[15]
See also
References
General references
- Clew, Kenneth R (1977): Somersetshire Coal Canal and Railways. David and Charles, Newton Abbot, UK. ISBN 0-7153-4792-6.
- Uhlemann, Hans-Joachim (2002): "Canal Lifts and Inclines of the World" Internat, Horsham, UK. ISBN 0-9543181-1-0.
Inline citations
- ^ "Levels at Rowley Bottom". The Somersetshire Coal Canal Society. Retrieved 6 September 2013.
- ^ a b Robert Weldon, quoted in Billingsley, John (1795). "Robert Weldon's Hydrostatick or Caisson-Lock". General view of the agriculture of the county of Somerset (1798 ed.). London: Charles Dilly. pp. 316–318. OCLC 614002204.
- ^ "The Combe Hay Caisson Lock". Bath Royal Literary and Scientific Institution. Retrieved 8 August 2016.
- ^ "History of the Somersetshire Coal Canal". The Somersetshire Coal Canal (Society). Archived from the original on 13 October 2006. Retrieved 8 October 2006.
- ^ "The Somerset Coal Canal". Bath Royal Literary and Scientific Institution. Retrieved 8 August 2016.
- ^ "History of the Caisson Lock On the Somersetshire Coal Canal". The Somersetshire Coal Canal (Society). Archived from the original on 11 October 2006. Retrieved 6 October 2006.
- ^ Oxford English Dictionary, Second Edition 1989, Oxford University Press.
- ^ See diagram.
- ^ Russell, Ronald (1971): Lost Canals of England and Wales. David and Charles, Newton Abbot, England. ISBN 0-7153-5417-5
- ^ Patent 3670, 23 March 1813
- ^ "Patent for the modes of constructing of locks and sluices for canals, etc". The Repertory of Arts Manufactures and Agriculture. 23: 281–285. 23 March 1813. OCLC 6994343.
- ^ Spencer, Herbert (1961). London's canal: the history of the Regent's canal. Putnam. p. 36. OCLC 3799561.
- ^ Faulkner, Alan (2005): The Regent’s Canal: London’s Hidden Waterway. Waterways World Ltd. ISBN 9781870002592
- ^ Spencer 1961, pp 44–45; 49
- ^ "Account of new patents". The Repertory of Patent Inventions. 8: 466. 1 May 1828. OCLC 7922094.